A Uniden representative should be able to provide you with sample frequencies, or use the enclosed order form to purchase a local frequency list. When a transmission is received, the Scanner stops on that channel. This plug will fit into the power outlet only one way. You will hear what is broadcasting on the frequency once it is entered. Programming a Base Model on the Uniden Bearcat Scanner Connect the scanner to its supplied antenna, or use an external antenna for better reception. If your scanner stops during Scan mode and no sound is heard, it may be receiving a birdie. Lockout in Manual Mode Press Select a channel.
Always write down the programmed frequencies in the event of memory loss. Press to unlock the channel. If you need to improve reception, use an optional antenna designed for multi-band coverage. Radio-frequency scanners, like the Uniden Bearcat Scanner, check for active radio communications in your immediate area. Enter lower limit of the search band.
Chris earned Bachelor of Arts degrees in journalism and English from Truman State University. For example, if the frequency is 123. Group similar frequencies into adjacent channels. Weather Scan — Use as a weather information radio. Setting the Squelch To set the Squelch, you must be in the Manual Mode. The display will flash to show the frequency has been stored successfully. Wait until the scanner stops at the channel.
Attach the flexible antenna, or connect your portable to an external antenna for better reception. Press and hold for two seconds to designate this channel as your new. Then press The scanner immediately resumes scanning because the. Either press begin your search. If you get no response from a know frequency, then the squelch pot may need cleaning or replacement may be in order. Select frequencies from your starter guide. For example, warehousers can use them to monitor communications between warehouse staff, truckers and security guards.
No signal should be present when adjusting squelch. When the scanner is operating, anytime a signal goes to that channel it will automatically switch to it and you will hear the transmission. You can restore the channel to scanning whenever you wish. Press When the scanner stops at the frequency you want,. Cost for repair at service shop may not be feasible. Note: You can program 10 skip frequencies.
Include the decimal point in the correct place or the scanner will not recognize the frequency. When the transmission ends, the scanning cycle resumes until another transmission is received. Channels: Search Bands: Frequency Range: Operating Temperature: Scan Rate: Search Rate: Scan Delay: Audio Output: Power Requirements: Antenna: External Jacks: Size: Weight: Features, Specifications, and availability of optional accessories are all subject to change without notice. You can purchase this type of antenna at a local electronics store. For example, if the frequency is 123. See the Table on page 3 or the Band List on the back of the scanner.
The scanner contains no serviceable parts. It allows you to program the device to scan the most important emergency frequencies in your area. You will hear two beeps when all the channels have been restored. Note: It is not advisable to program a weather frequency into one of the 30 channels since weather channels transmit continuously. You can usually find a copy of the manual on line, or google for instructions. Note: Your scanner searches each selected Personal Chain Search band.
If you program the wrong limit, press , then press again to erase the error and reset the limits to zero. Answered on Dec 23, 2015 The letter P is for Priority. Answered on Jun 14, 2014 The Bearcat Scanner is neat hand held scanner, Is the scanner programed? Use the included earphone or an optional stereo. Then press can receive radio broadcasts, you. The address and phone number are listed in the Warranty at the end of this manual, or call 1-800-297-1023. They're commonly purchased by hobbyists, but they also have many business applications.
Then press Note: To clear a mistake while entering the frequency, press twice, and start over. Choose a storage bank for your first frequency. If the scanner beeps, that indicates you've already programmed that frequency into a different channel. Press and hold for about two seconds. Press Select a new Priority Channel.