Panasonic d1232 installation manual. Panasonic KX 2019-01-24

Panasonic d1232 installation manual Rating: 7,3/10 1723 reviews

Panasonic 16SLC Digital Super Hybrid System programming and installation manual

panasonic d1232 installation manual

Expansion area 2 Expansion area 1 Expansion Unit Connectors Remove the front cover plate s. Outside screw Secure the inside screw included to fix the cabinet to the main unit. Connect the cord to the Remote Card Connector. Note If any cards, units, or cords are installed to the main unit, remove them beforehand. Replace the cover and tighten the screw. Connect the wires of doorphone 2 to the yellow and black screws of the terminal box.

Next

Panasonic

panasonic d1232 installation manual

Installation Manual Extension Reverse here General Installation. Connect the wires of doorphone 2 to the yellow and black screws of the terminal box. Otherwise, the system will not start up with the default values. The serial number of this product may be found on the label affixed to the bottom of the unit. To Terminal Board or Modular Jacks from the Central Office Tie all of the cords into a bundle.

Next

Panasonic KX

panasonic d1232 installation manual

Connect the cord to the Doorphone Card Connector. Insert fingers into the slits to remove the cover plate. System Restart causes the following: Camp-on is cleared. The 50-pin connector Jack on the Expansion Unit has two hook-pins. A lightning strike to a telephone cable which is 10 m 33 feet above ground can be as high as 200,000 V.

Next

Panasonic 16SLC Digital Super Hybrid System programming and installation manual

panasonic d1232 installation manual

Insert your fingers into the slits to remove the cover plate. Slit Note There are two cover plates. Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. Drive the screw to this position Hook the main unit on the screw heads. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. Expansion area 3 Expansion area 2 Expansion area 1 Expansion Unit.

Next

PANASONIC KX

panasonic d1232 installation manual

Connect the grounding wire to ground. Use a 2 wire cord. The system will restart with the default setting. Before restarting the system, try the system feature again to confirm whether there definitely is a problem or not. This unit can be installed to any of the expansion unit areas provided on the front of the main unit.

Next

PANASONIC KX

panasonic d1232 installation manual

Quantity 24 per extension proprietary telephone 10 per extension Installation Manual. The initially provided Outside Line Card is located behind the inside cover. Connects two Digital — Super Hybrid Systems. For installation, Refer to 2. This system should be installed with lightning protectors. Inside screw Note Be sure to fix the inside screw to the main unit, or the unit may not work properly.

Next

Panasonic KX

panasonic d1232 installation manual

Consult your authorized Panasonic dealer for detailed instructions. Hook the cabinet to the main unit and slide the cabinet to the left until it is secured. Insert fingers into the slits to remove the cover plate. Product service Panasonic Factory Servicenters for this product are listed in the servicenter directory. Programming Guide Provides system programming instructions.

Next

Panasonic

panasonic d1232 installation manual

General Description Capacity Control Method Power Supplies Connectors 2. Note System Programming is required for expansion unit location. Slide the cover while pressing the Note The screw cannot be removed from the unit. Connect the cabinet cord to the connector in the main unit firmly. This card supports the Message Waiting feature for a single line telephone with a message waiting lamp. Loosen the screws on the terminal strip. If this unit is installed, other optional cards which extend outside lines cannot.

Next

Panasonic KX

panasonic d1232 installation manual

Installation Manual Main Building Main. They share the same extension number and are considered by the system to be one extension. Refer to the Telephone Wiring Page 48 and Pin Number Chart Page 51. Do not use the telephone to report a gas leak in the vicinity of the leak. Use a conduit to protect the wire. Outside screw Secure the inside screw included to fix the cabinet to the main unit.

Next