Prepare the computer for disassembly Section 5. The Application and Driver Recovery tool opens. Reseat loose Loose or components and damaged boards and parts? Bottom Components Table 1-8 Bottom Components Item Component Function Battery bay Holds the battery. Releasing the Backlight Cables C—10 Maintenance and Service Guide. Contents 1 Product Description 1. Open the computer as far as possible.
Any warranty support needed would be completed by the third party that sold the product. Prepare the computer for disassembly Section 5. Vents 5 Enable airflow to cool internal components. Disconnect the speaker assembly cable 1 from the power button board. TouchPad and Keyboard User Guide © Copyright 2006 Hewlett-Packard Development Company, L. First Edition: July 2006 Document Part Number: 416611-001 Table of contents 1 Digital Media Slot cards select models only Inserting a digital card. Disassembly Sequence Chart Section Description of Screws Removed Preparing the Computer For Disassembly Battery Hard Drive 2 loosened to remove the hard drive cover.
Computer Feet Locations Maintenance and Service Guide 5—11. Remove from docking device if applicable. Insert the first recovery disc into the optical drive and restart the computer. Prepare the computer for disassembly Section 5. Remove the inverter 1 from the display enclosure. Disposal of mercury may be regulated because of environmental considerations. For disposal or recycling information, contact.
Keyboard Components 1—12 Maintenance and Service Guide. Removing the ExpressCard Slot Bezel Maintenance and Service Guide 5—57. Amber: All wireless devices are turned off. The information contained herein is subject to change without notice. Click Advanced Options on the System Recovery screen. Some additional features this laptop has is a 1. Lift the right side of the cover 2 and swing it to the left.
The information contained herein is subject to change without notice. Top Components, Part 2 1—16 Maintenance and Service Guide. Because of the complexity of the individual boards and subassemblies, do not attempt to make repairs at the component level or modifications to any printed wiring board. Microsoft and Windows are U. Select Delete Recovery Partition not recommended and follow the on-screen instructions.
Removing the Top Cover Screws, Part 1 Maintenance and Service Guide 5—47. Remove the switch cover Section 5. Removing the Top Cover Reverse the above procedure to install the top cover. Keyboard Replace internal operating keyboard or properly? Removing the Display Inverter Board Maintenance and Service Guide C—5. Removing the Backlight Cover Maintenance and Service Guide C—9.
Removing the Display Bezel Screw Covers and Screws Maintenance and Service Guide C—3. Product sold by third party: This product was sold by a third party. The power cord set included with the computer meets the requirements for use in the country where the equipment is purchased. Failure to support the display assembly can result in damage to the display assembly and other computer components. Open the computer to an upright position. The information contained herein is subject to change without notice. Circuitry design and structure determine the degree of sensitivity.
If you are unsure whether the computer is off or in hibernation, turn the computer on, and then shut it down through the operating system. Reseat internal keyboard connector if applicable. Removing the Display Bezel C—4 Maintenance and Service Guide. Lift up and out on the left and right inside edges 1 and the top and bottom inside edges 2 of the display bezel until the bezel disengages from the display assembly. Recovering from the Partition on the Hard Drive You can perform a recovery from the partition on the hard drive.
Notebook Tour User Guide © Copyright 2006 Hewlett-Packard Development Company, L. Correct Load drivers and drivers for set configuration application? Selecting from the Main Menu Table 2-1 Main Menu Select. Do not move or transport the computer when an ExpressCard is in use. Reseat power cord in docking device and power outlet. © Copyright 2006, 2007 Hewlett-PackardDevelopment Company, L. Disconnect the display cable 2 and the backlight cable 3 from the display inverter.