I couldn't believe how well it handled in the snow. With hundreds of pages, it will show you how to distinguish any problem from an oil change to a transmission swap and how to fix it on your own. Do not place in an outboard seating posi-tion and attempt to angle the tether strap to the center position. Low fuel warning This warning appears when the fuel level in the tank is getting low. For more information, visit www.
Remove water drops, snow, ice or sand from the moonroof before opening. If you cannot comfortably lift the items onto the roof rack from the ground, use a ladder or stool. Push the front or back end of the switch to adjust the seatback lumbar area. When the window lock position is pushed off, the rear moonroof can be operated. Tilt the console box forward and install the front of the console box so that the hook engages the slot in the base.
When the cruise main switch indicator light illuminates, the cruise control system is operational. This can damage the seat or occu-pant classification sensors. The moonroof will operate in the close direction. Some child re-straints may not fit properly in your vehicle. Trip odometer: The trip odometer mode shows the total distance the vehicle has been driven since the last reset.
The outlet and plug may be hot during or immediately after use. Properly adjust the head restraint before an occupant uses the seating position. Always sit well back in the seat with both feet on the floor and adjust the seat belt properly. When installing a child restraint system in the 3rd center position, both the center seat belt connector tongue and buckle tongue must be secured. The headlights blink and the horn sounds intermittently. Failure to do so may reduce the effectiveness of the entire restraint system and in-crease the chance or severity of injury in an accident. Placing them inside the steering wheel rim could in-crease the risk of injury if the front air bag inflates.
Engine coolant temperature gauge 9. Not all child restraints fit in all types of vehicles. Armrest 2nd row seat P. They could un-knowingly activate switches or con-trols. The power seat motor has an auto-reset overload protection circuit. If the head restraint or headrest is removed, store it in a secure place.
Follow these steps to install a forward-facing child restraint using the vehicle seat belt in the rear seats or in the front passenger seat: 1. Check to make sure the child restraint is properly secured prior to each use. Do not touch them; you may severely burn yourself. If the booster seat is compatible with your vehicle, place your child in the booster seat and check the various adjustments to be sure the booster seat is compatible with your child. Some examples of danger-ous riding positions are shown in the illustrations.
After a few driving trips, the light should turn off. Release the lever to lock the seat in position. Push and hold the lock knob and push the headrest down. Seat belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted. The front air bags inflate quickly in order to help protect the front occupants. Do not place cargo higher than the seatbacks.
Always reconnect the center seat belt when the seat is returned to the upright position. To close, push the lid in until the lock latches. Headlight, fog light and turn signal switch — Headlight P. This button is usually located near the antenna wire that hangs down from the motor. Windshield wiper and washer — Switch operation P.
It goes a long way in pushing back against the typical boring minivan look. Have the brakes checked as soon as possible if the warning sound is heard. If a malfunction occurs in the system, the vehicle dynamic control system function will be canceled but the vehicle is still driveable. The road surface may be slippery. This is a must for the Do-It-Yourselfer! High-mounted stop light — Bulb replacement P. They may interfere with side air bags inflation.