It is an in-line fuel filter located behind the rear bumper. Power Steering Fluid and Trans Fluid next! I changed my filter this past weekend and broke one of those damn little clips. The tool isn't very expensive and usually comes in a set of several different sizes. Explanation The powertrain control module monitors fuel system pressure. Start the vehicle and check the filter and lines for leaks. There should be two on each side. Here is a view of the locking device within the fuel lines.
In order to do this you need a special tool to break the fan nut free. Step-7: Remove Turbo Now the turbo can be removed from the pedestal. On a 1996 Mustang with a 3. Oil from your fingers can severely shorten the life of the bulb. You will know you have been successful in doing so when the motor gives out.
Sometimes the click is very quiet, so test the fitting by gently pulling on the line to see if it comes loose. Make sure that the tabs on the clip are positioned correctly and the loop-type spring is away from the rotor. Position the new fuel filter into the clamp with the arrow pointing in the proper direction. Go to Strutmasters and call them. It is in great shape but it has 126000 miles on it.
You push the plastic ring down into the fuel line connection to release the fuel line from the fuel filter. Definition Fuel rail pressure sensor condition. Does your truck feel like yourself on a Monday morning after a weekend of partying? I promise you that some components will be a challenge to remove, but it can be accomplished. Disconnect the negative battery cable. Slide under the driver side of the Expedition and locate the fuel filter, which is mounted to the frame rail directly in front of the gas tank. Follow the instructions with the tool.
Push the filter into the retaining clamp aligning the front lip on the filter into the groove. Any help would be great. Remove the catch pan from underneath the truck. I pulled 44 and started the car and it ran out of gas in less than 10 seconds. This will release the fuel line from the fuel filter port.
This box will disappear once registered! Just the center piece is pushed out with the plier. . After the lines are detached,check the fittings for damage and distortion. Step-2: Remove Air Conditioning Condenser Remove the front grille and the headlight assembly to gain access to the cooling accessories in the front. They push right back onto the new filter and click when passing the hump on the filter stem.
Hold the fuel filter up to the threads and start screwing the fuel filter clockwise until it starts on the threads. Fuel pressure low - fuel pump defective. Grasp the fuel filter and carefully pull it straight out of the retaining clamp. Set the metal guard to the side. Fold the plastic shield toward the windshield and secure it to the wiper arms by a zip strap.
To reinstall just reverse the process. It's also a reason why there is no shrader valve to check the pressure. Copyright © 2009 - Powerstrokehub. The guy there told me that since it had the clips in the box I shouldn't need the tool. An oral syringe or turkey baster work well. It is very important to replace it on time.