Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Buckle the combination lap and shoulder belt. Remove console finish panel assembly to expose the inside of the gearshift. Connect the negative - cable to the negative - terminal of the assisting battery. If the light flashes steadily or does not illuminate, have the transmission serviced soon, or damage may occur. Add the mixture to the coolant reservoir, when the engine is cool, until the appropriate fill level is obtained.
Trip odometer: Registers the miles kilometers of individual journeys. What you need to do is download this repair manual and show it to your mechanic. If other than Ford, Motorcraft or Ford-authorized parts are used for maintenance replacements or for service of components affecting emission control, such non-Ford parts should be equivalent to genuine Ford Motor Company parts in performance and durability. This program is separate from the New Vehicle Limited Warranty. After the code is entered, the locks will cycle, confirming that the new code has been set. If the retractor is not locked, unbuckle the belt and repeat steps two through nine. Running out of fuel Avoid running out of fuel because this situation may have an adverse affect on powertrain components.
The system will allow your vehicle to make better use of available traction in these conditions. Do not tow with a slingbelt. Refer to Lubricant specifications in this chapter. Besides, it also tells you the Ford F150 towing capacity. Defrost: Distributes outside air through the windshield defroster vents and demister vents. Ford Motor Company shall not be responsible for any such programming changes. The flow of fuel through a fuel pump nozzle can produce static electricity, which can cause a fire if fuel is pumped into an ungrounded fuel container.
Ford recommends the use of a digital or dial type tire pressure gauge rather than a stick type tire pressure gauge. Contact your dealer if the window sticker is not supplied with your vehicle. Make sure the jack is fastened so it does not rattle when you drive. Doing so will produce excessive noise, increase tire wear and may damage drive components. The front passenger outboard and rear outboard seat safety belts have two types of locking modes described below: Vehicle sensitive mode The vehicle sensitive mode is the normal retractor mode, allowing free shoulder belt length adjustment to your movements and locking in response to vehicle movement. Make sure the parking brake is set. Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death.
If your vehicle will be towing a trailer, load from your trailer will be transferred to your vehicle. Use only Ford recommended replacement fasteners. For more information on top tether straps and anchors, refer to Attaching safety seats with tether straps in this chapter. Do not use tire chains on dry roads. The key codes need to be erased from your vehicle and new coded keys will need to be programmed.
If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount. Failure to activate your headlamps under these conditions may result in a collision. Remove the jumper cable from the ground metal surface. It's a stupid rule in our opinion, but they authorize our manuals and that's what their lawyers require. Sitting on the safety belt will increase the risk of injury in an accident. To extend the bed extender: 1. Refer to the Lubricant specifications section in this chapter.
Power steering fluid reservoir 5. This mini-buckle should stay buckled at all times unless cargo-carrying makes it necessary to detach the belt. The compass is now calibrated. Refer to Brake fluid reservoir in the Maintenance and Specifications chapter. The front passenger air bag is not designed to offer protection to an occupant in the center front seating position.
When driving the vehicle off road, the bed extender should be removed and the tailgate closed. On the wall or screen you will observe a light pattern with a distinct horizontal edge towards the right. Gently pull on the cover to make sure it is seated properly. Away from home If you own a Ford or Mercury vehicle and are away from home when your vehicle needs service, or if you need more help than the authorized dealer could provide, after following the steps described above, contact the Ford Customer Relationship Center to find an authorized dealer to help you. The top of the message center must be blank. Also use in menu mode to select various settings. Bins adjacent to the End Cap must be pinned to the End Cap.
Repeat step 3—5 for the other headlamp. The head restraints can be moved up and down. Booster seats position a child so that safety belts fit better. If there is difficulty in turning the key, rotate the steering wheel until the key turns freely. To obtain reimbursement information, U.